Brush polisher and safety filter ps2/b

  • Near complete powder recovery thanks to the notable surface area of the high-efficiency electrostatic filters (7 m2 every two places);

  • 1.5 kW motor 2800 r.p.m. Shaft prearranged for three brushes, one of which is horsehair while the remaining two have a diameter of 180 mm and are for roughing and polishing pastes;

  • Emergency stop device for the motor activated by a pedal control;

  • 2.2 kW centrifugal suction fan;

Burn-out furnaces with rotating plate (for flask baking in the casting process)

Furnaces with rotating plates for the drying of plaster cylinders and the draining of wax, used in the melting process of lost wax objects.


These units are used to rinse and dry chains, metal findings, silver slime and/or silver crystals and are built out of polished stainless steel with a statically and dynamically balanced extractable basket.

Electrolytic cleaning plants igp/b

The degreasing, neutralising and recovery tanks are equipped with discharge valves, the rinsing tank is equipped with a spill overflow. A 250 A/20V rectifier with current limit for the degreasing and cleaning tanks is included. All required control instruments such as amperometers, voltmeters and temperature regulators are also included. The plant is also equipped with a polypropylene suction fan and intake manifold for the heated tanks.
The electrolytic cleaning solutions can be with or without cyanide.

Gold, rhodium, silver and nickel plating galvanic plants

The plating plants are made out of self-extinguishing polypropylene. The temperature of the solutions is adjustable by thermometers with glass protected bulbs. An electronic rectifier ensures a perfect voltage stabilisation even in presence of current or load peaks.

Investment disintegrator type dsg/a

The investment breakers are used to remove the refractory investment from the objects obtained by vacuum casting and recover particles of precious metal.

Investment mixing machine type mrc

The vacuum mixing and pouring cycles have very short cycle times. Thanks to this, the compaction of the investment gives roughness free surface finish and reduces pre-finishing times as well as eventual loss of precious metals.

Pickling equipment type idf

The equipment pickles and removes investment from the surface of casted pieces.

Vacuum / pressure casting furnace model fim/mce

The MCE vacuum casting furnace is used to produce casted jewellery as well as ingots or sheet.

Vulcanising press pvg/a

The vulcaniser is used to prepare rubber moulds for vacuum casting. A painted steel frame supports a 4 column hydraulic press with 250x250 mm cast iron heated plates. The main advantage offered by this press is the automatization of the working cycle, leaving workers free to carry out other jobs.